Automatic Cantilever Gates
Cantilever sliding gate systems do not require a ground track - this can be advantageous where the driveway entrance slopes, busy or heavy traffic entrances or where minimal disturbance to the driveway surface is requested.
The main design difference from a tracked system is that the cantilever system has a special section bottom rail in which incorporates two sets of enclosed roller wheels set apart at a pre- determined distance to a large concrete foundation base.
The cantilever sliding gate is approx 1/3 longer than a tracked slider, the extra length acts as a counterbalance so that the gate is free to slide back and forth, supported throughout the entire opening/closing width by the roller wheels within the bottom rail.
There is a slam post assembly at one end and stops at the other end to ensure that the gate cannot slide free of it mountings and fall over. Often the lower leading edge has a wheel which engages into a guide/shoe to ensure correct engagement upon closing.
The gate is held up-right by a guide rail and a roller. Guides positioned at the mid or top rail height.
In the manual mode the gate is very easy to slide open and closed as the roller wheels incorporate precision bearings.
The method of automation is based on a rack and pinion principle, the motor unit has a drive gear which engages into a linear rack positioned on the lower inside face of the gate, the motor gear wheel simply drives the gate open and closed.
The motor incorporates a electronic controls which can be set up to the correct closing force and open/close positions. It can also provide a smaller opening aperture to allow pedestrian only access if required.
E - Catalogue